HeatGuard

DESCRIPTION

Single component silicone acrylic base air drying Heat Resistance coating black Up to 400° C for good solvent, chemical resistance and corrosion protection. 

RECOMMENDED USE

It is recommended as a heat resisting coating for Chimney, Boiler, engine parts, storage tank, muffles, Pipes, doors & windows, electrical equipment etc. Recommended as finish coat for insulated surfaces in systems with suitable primers. Suitable for properly prepared carbon steel, galvanized steel, stainless steel and aluminum substrates. 

TECHNICAL DATA

COLOR                                                                              Black

FINISH                                                                               Smooth & Matt

HEAT RESISTING CAPACITY                                      Upto 400°C

SOLID CONTENTS                                                        60 +/- 5 %

THEORITICAL COVERAGE                                      14 - 12 Sq. mt/ltr. At 30 µm DFT

FLASH POINT                                                              > 30°C

DRYING CHARACTERISTICS (At 30°C)                     SURFACE DRY: 5 minutes

                                                                                       Tack Free Dry: 1 hrs.

                                                                           Hard Dry: 12 hrs.

SHELF LIFE (AIRTIGHT ORIGINAL CONTAINER):            Twelve Months

APPLICATION DETAILS

APPLICATION METHOD                                                 :       By Brush/By Conventional spray.

THINNER                                                                          :       ST-401.

RECOMMENDED DFT                                                       :      30 – 35 µm

Generally, no thinner is required for brush application, however under adverse environment conditions about 5% of thinner. By volume, can be added. Apply evenly in crisscross manner and ensure the uniform application. Use quality brushes for paint application.

For conventional spray application       

Nozzle orifice       :  1.2 – 1.4 mm                                                         

Nozzle pressure   :  40 – 70 Psi                                                                           

Thinner                  :  ST-401

Addition                :  3-5%

HEATGUARD BLACK 400°C

SURFACE PREPARATION

To secure lasting adhesion to the subsequent product all surfaces should be clean,dry and free from any contamination.

Additional information

Further information regarding industry standards, terms and abbreviations used in this data sheet can be found in the following section of NEO’s data manual.

Ø  Product data sheet guide.

Ø  Surface Preparation Details

Ø  Paint Application Details

Ø  MSDS

Notes

1.       Do not apply paint when temperature falls below 10°C or rises above 50°C and when Relative Humidity is above 85%, or during rain, fog or mist, surface temperature must be minimum of 3°C above Dew point.

2.       Brush and Spray equipment should be cleaned with NEO’s recommended thinner otherwise equipment is liable to damage.

3.       DFT variation can be obtained by change in application method/thinning ratio. Contact NEO’s Representative for further assistance.

4.       Shelf life indicated is minimum of this product in sealed condition. Individual component required to store in cool, dry and covered condition, away from heat and ignition.

Health & safety

This is a solvent-based paint and care should be taken to avoid inhalation of Spray mist or vapor as well as contact between the wet paint and exposed skin or eyes.

Limitation of Liability

To the best of our knowledge, the technical data in our literature are true and accurate at the date of issuance but are subject to change without prior notice. We guarantee our product to conform specifications contained herein. We make no any other warranty or guarantee of any kind, express or implied including merchantability and fitness of particular purpose.  Liability, if any islimited to replacement of the product or refund of the purchased price. Labor and cost of labor and other consequential damages are hereby excluded.